Open Access 
Downloads
Download data is not yet available.
Abstract
In drilling hydraulic calculations, the pressure drop modelling plays an important role. The exact modelling can increase the rate of penetration and reduce the drilling costs, and conversely, miscalculations may cause potentially problems such as fluid loss, well damage. This paper presents the modelling of pressure drop for the vertical drilling well and the directional drilling well in three different procedures. There are the in-field procedure and two procedures from the petroleum software’s Hydmod and Drilling Office. These obtained results are compared and analysed to show the confidence and potential of these commercial software applied in petroleum industry.
Author's Affiliation
Article Details
Issue: Vol 6 No 11 (2003)
Page No.: 98-106
Published: Nov 30, 2003
Section: Article
DOI: https://doi.org/10.32508/stdj.v6i11.3383
Copyright Info
Copyright: The Authors. This is an open access article distributed under the terms of the Creative Commons Attribution License CC-BY 4.0., which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
How to Cite
Tu An, B., Kien Cuong, N., Quang Khanh, D., Huu Tuan, T., & Phuoc Hao, L. (2003). PRESURE DROP MODELING IN DRILLING HYDRAULICS. Science and Technology Development Journal, 6(11), 98-106. https://doi.org/https://doi.org/10.32508/stdj.v6i11.3383
Download Citation
Cited by
Article Statistics
HTML = 917 times
Download PDF = 340 times
Total = 340 times
Download PDF = 340 times
Total = 340 times
Most read articles by the same author(s)
- Nguyen Kien Cuong, Le Phuoc Hao, Trinh Huu Tuan, Do Quang Khanh, APPLYING NODAL ANALYSIS APPROACH FOR OPTIMIZATION OF TUBING DIAMETER , Science and Technology Development Journal: Vol 6 No 11 (2003)
