Open Access  

Downloads

Download data is not yet available.

Abstract

Electrical discharge machining (EDM) has found widespread applications in tool , mold and aerospace industries. Therefore, enhancement of the quality of the EDM process has become a major research concern. In this paper, the effect of various titanium powder concentrations on the Material Removal Rate (MRR), tool wear rate (TWR), surface roughness (Ra) in powder mixed electrical discharge machining (PMEDM) have been studied. The workpiece is SKD61steel and electrode made from copper with reverse polarity were used in experimental study. The results showed that titanium powder mixed into the dielectric fluid of EDM can enhance MRR without increasing TWR and Ra.

Author's Affiliation
Article Details

Issue: Vol 18 No 2 (2015)
Page No.: 43-51
Published: Jun 30, 2015
Section: Engineering and Technology - Research article
DOI: https://doi.org/10.32508/stdj.v18i2.1058

 Copyright Info

Creative Commons License

Copyright: The Authors. This is an open access article distributed under the terms of the Creative Commons Attribution License CC-BY 4.0., which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

 How to Cite
Banh, L., Ngo, C., & Nguyen, P. (2015). Investigation into effects/Investigating the effects of titanium powder concentrations mixed in dielectric fluid on material machining removal and surface roughness of SKD61 steel after electrical discharge machining by reverse electrode polarity. Science and Technology Development Journal, 18(2), 43-51. https://doi.org/https://doi.org/10.32508/stdj.v18i2.1058


 Download Citation
 Cited by

Article level Metrics by Paperbuzz/Impactstory
Article level Metrics by Altmetrics

 Article Statistics
HTML = 1649 times
Download PDF   = 820 times
Total   = 820 times