Open Access  

Downloads

Download data is not yet available.

Abstract

This paper presents a theoretic and practical approach to confirm the dynamic errors induced by acceleration on CMMs during fast measuring. To simplify, a physical model, a mathematical model of the bridge component and the prismatic joint that move along X axis of a bridge CMM are presented. The research points out that there is sure to be the dynamic errors when there is acceleration. This has been demonstrated by the simulation of the errors on the tip probe by Matlab sofware and the experimental results are obtained. The dynamic errors will decrease the accuracy of CMMs so it is necessary to make out a compensation software to keep up the the accuracy of the measuring results.

Author's Affiliation
Article Details

Issue: Vol 15 No 1 (2012)
Page No.: 60-68
Published: Mar 30, 2012
Section: Engineering and Technology - Research article
DOI: https://doi.org/10.32508/stdj.v15i1.1775

 Copyright Info

Creative Commons License

Copyright: The Authors. This is an open access article distributed under the terms of the Creative Commons Attribution License CC-BY 4.0., which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

 How to Cite
Thai, H., & Pham, T. (2012). INFLUENCE OF ACCELERATION ON THE CMMS ACCURACY IN FAST MEASURING. Science and Technology Development Journal, 15(1), 60-68. https://doi.org/https://doi.org/10.32508/stdj.v15i1.1775


 Download Citation
 Cited by

Article level Metrics by Paperbuzz/Impactstory
Article level Metrics by Altmetrics

 Article Statistics
HTML = 1325 times
Download PDF   = 588 times
Total   = 588 times